Professional Heating Repair, Maintenance & Installation in Richmond

Common Heat Pump Repairs

• Outdoor unit freeze-overs can commonly happen due to low refrigerant levels, a malfunctioning defrost cycle, or poor airflow. This can cause increased strain on your system.
• Low refrigerant levels can be caused by a refrigerant leak, which means your heat pump is unable to absorb and transfer heat to your home efficiently.
• A faulty reversing valve can cause your heat pump to remain stuck in either the heat or cooling mode.
• A thermostat or sensor malfunction can result in incorrect readings, frequent cycling, and uneven heating throughout the home.
• Electrical issues can cause the outdoor unit to stop working or run improperly.

Common Furnace Repair Problems

• Dirty or backed-up filters can result in reduced efficiency due to poor airflow and overheating.
• Pilot light failure is often caused by a faulty igniter, thermocouple malfunction, or dirty burner.
• Blower motor issues can result in excess noise or system failure.
• A cracked heat exchanger can cause carbon monoxide to leak into the air.
• A thermostat malfunction can cause the system to short-cycle or run longer than it needs to.

Common Boiler Problems

• Low water pressure can cause reduced efficiency and noisy operation. This problem is caused by leaks or a valve issue.
• Leaking pipes are usually the result of corrosion, rust, or worn connections. This can cause water damage and reduce efficiency.
• Limescale buildup in the heat exchanger can lead to overheating.
• Pilot light issues could be the result of a thermocouple malfunction, a gas valve issue, or a dirty pilot light assembly.
• Trapped air in the system could decrease system efficiency.

Heat Pump Maintenance

During a heat pump maintenance check, you can expect our professionals to:

• Check for blockages or leaks in the indoor and outdoor vents.
• Ensure the heat exchangers are clear of corrosion, cracks, or separations.
• Test the transfer from heating to cooling modes.
• Clean coils
• Check refrigerant levels and look for signs of overheating.
• Change the air filter.
• Lubricate the blower if needed.

Furnace Maintenance

While there are some common things to check for between furnaces and heat pumps, there are also some differences, including:

• Filter changes
• Inspect the blower and clean as needed.
• A full inspection of vents and the heat exchanger
• Ensure the motor is properly lubricated.
• Test the thermostat and furnace function.

Boiler Maintenance

Boiler maintenance requires a precise balance of fuel and air for it to be efficient and safe. Our boiler service technicians are trained and certified in combustion analysis. When we do our boiler maintenance checks, we go in-depth, saving our customers an average of 25% on their energy bills.

During a routine tune-up, you can expect:

• A visual inspection of the system to ensure that it is installed and positioned correctly.
• Check that it is operating efficiently and safely.
• Identify potential problems and repair if necessary.
• Cleaning of the internal components, including the removal of sediment or limescale buildup
• Inspection of pressure levels and valves